VENCO DIRECT DRIVE POTTERY WHEEL
Please contact the shop prior to ordering.
- Motor: Direct drive 550W (3/4 HP) permanent magnet- no belts or pulleys (nothing to tension, no belt thump)
- - brushless design (maintenance free)
- - ultra quiet and incredible low-speed torque
- Completely redesigned circuit board
- Greater stability with five feet that will be pivoting and height adjustable-photos just show with usual rubber feet as waiting on new stock
- New more robust and IP rated foot pedal.
- Elongated drain spout allowing easier collection of slurry runoff
- Stylish new touch pad.
- Intelligent microprocessor based control system for smooth, precise control- super quiet and smooth
- can be used as a floor or table model (remove legs)
- Energy efficient - low power consumption.
- 0 -300 RPM
- compact for easy storage
- CE approved
- 110V- 240V 50/60hz operation
- Clip-on tray shelves - hand oiled plywood with aluminium brackets
- Standard wheel head bats - drilled with holes to match wheel head. (hand oiled plywood) approx 340mm diameter
- Riser bats - increased thickness bat for increasing the wheel head height above that of the tray rim for throwing large diameter platters etc. Made from hand oiled plywood.
- Stand-up kit. - stainless steel extension legs for stand-up throwing. Increases wheel head height to 84cm (33") from floor level.
- Leg feet. - extra feet may used to adjust the height of the wheel to personal taste. Up to three feet may be used on each leg. Each foot increases the height of the wheel by 22mm ( 7/8"). A set of three feet (one for each leg) is supplied as standard with each wheel.
Warranties on wheels are:
The Motor is 10 years
The warranty on the circuit board and Foot pedal is 3 years.
Address: 59 Mcroyle St, Wacol QLD 4076
Sorry, there are no perks or discounts for ordering two wheels as unfortunately Venco give no large quantity discounts.